Stjarnagloss Glö Hydrophobic Snow Foam 1L - 1 Litre

NEW Glö – Protective Snow Foam with Gloss & Beading Add instant gloss and hydrophobic protection after your contact wash—effortlessly. What happens when you combine Glatt and Snö?You get Glö: a protective snow foam that merges the fun of snow foaming with the beading we all crave, all in one simple post-wash step. Designed to be used after the pre-wash and contact wash stages, Glö is applied just like a traditional snow foam—but instead of watching dirt slide away, youll see (and hear) the foam crackle and disperse, leaving paintwork and glass unbelievably glossy and covered in tall, proud water beads. Rinse, towel dry, and stand back.The car will be glowing. Why Choose Glö – Protective Snow Foam? Gloss & Protection in One StepAdds a slick, glossy finish and a hydrophobic protective layer without additional sealants or sprays. Snow Foam Meets BeadingCombines the visual satisfaction of snow foaming with the instant gratification of water repellency. Efficient & EconomicalA single litre of Glö concentrate delivers approximately 20–40 protective layers, meaning you wont use anywhere near a full lance per car. Designed for Pressure Washer UseFor best results, apply with a professional snow foam cannon and a pressure washer capable of 130 bar or more. For maximum cleaning before protection, pair Glö with Snö X Intensive Snow Foam Pre-Wash. IMPORTANT – Snow Foam Cannon Care You MUST rinse out your snow foam cannon after using Glö.All hydrophobic or sealant-based snow foams can gum up the gauze and internals of snow foam lances if not flushed properly. After applying Glö: Run at least 1 litre of clean water through the snow foam lance Do this every time after use Failure to flush the lance may result in reduced performance or blockage.We cannot accept liability for snow foam cannons that fail due to improper cleaning. Replacement gauzes and lance cleaning guides are widely available online. How to Use Glö ApplicationApply Glö using a professional s